Safety
Monitoring Relays with Time Delay. Various output configurations (see below)
IDEM’s
SCR-4-TD range are all purpose safety monitoring relays that combine time
delayed and non time delayed contacts in a compact 22.5mm housing.
This
permits dangerous components of a system to be switched off quickly and safely,
whilst at the same time other circuits are still supplied with voltage for up
to 30 seconds (adjusted on the SCR-4-TD by a potentiometer).
If the
application requires time delayed opening of a safety circuit following
activation of the stop signal then the SCR-4-TD range will provide combination
of instant and variable delayed contacts.
This may be
useful for applications that rely on PLC control to provide an initial
controlled shutdown but ultimately requires a delayed opening of safety
circuit.
Variants
available:
SCR-4-TD-1
with Instant 3NC and Delayed 1NC
SCR-4-TD-2
with Instant 2NC and Delayed 2NC
SCR-4-TD-3
with Instant 1NC and Delayed 3NC
Featuring:
Force
Guided Safety output Contacts:
Standards:
EN60204-1, EN954-1, ISO13849-1, EN62061.
Stop
Category: 0 (non time delayed) 1 (time delayed).
Up to
Category 4 to EN954-1.
Up to PLe
to ISO13849-1.
SILCL 3
EN62061.
Single or
Dual Channel input with LED indication of input status.
Redundancy
cycle monitoring.
Feedback
loop for monitoring contactors or expansion modules.
Short circuit
and earth fault monitoring.
22mm Din
Rail Mounting.
SCR-4-TD:具有延時的安全監控繼電器
具有延時的安全監控繼電器。
各種輸出配置(見下面)
IDEM的SCR-4-TD系列是全用途安全監控繼電器，在緊湊的22.5mm外殼中結合了時間延遲和非時間延遲觸點。
這允許一個系統的危險部件被快速和安全地切斷，同時其他電路仍然提供高達30秒的電壓(通過電位器調整SCR-4-TD)。
如果應用程序需要在停止信號激活后延時斷開安全電路，則SCR-4-TD范圍將提供即時和可變延時觸點的組合。
這可能對依賴PLC控制的應用程序提供一個初始控制關機，但終需要安全電路的延遲打開有用。
變體:
SCR-4-TD-1具有即時3NC和延遲1NC
SCR-4-TD-2具有即時2NC和延遲2NC
SCR-4-TD-3具有即時1NC和延遲3NC
特色:
力導安全輸出
標準:EN60204-1、EN954-1、ISO13849-1、EN62061。
停止類別:0(非延時)1(延時)。
4級至EN954-1。
可達PLe至ISO13849-1。
SILCL
3 EN62061。
單路或雙路輸入，LED顯示輸入狀態。
冗余循環監測。
反饋回路監測接觸器或擴展模塊。
短路和接地故障監測。
22mm
Din Rail安裝。
聯系人：侯經理 聯系人：13661967205
